ATATMEL-ICE-BASIC  debugging and programming ARM  Cortex-M based SAM/AVR MCTR  (Atmel ICE)

Atmel-ICE is a powerful development tool for debugging and programming ARM® Cortex® -M based Atmel® SAM and Atmel AVR ® microcontrollers with OnChip Debug capability. It supports:

• Programming and on-chip debugging of all Atmel AVR 32-bit microcontrollers on both JTAG and aWire interfaces
• Programming and on-chip debugging of all Atmel AVR XMEGA ® family devices on both JTAG and PDI 2-wire interfaces
• Programming (JTAG and SPI) and debugging of all Atmel AVR 8-bit MCTR with OCD support on either JTAG or debugWIRE interfaces
• Programming and debugging of all Atmel SAM ARM Cortex-M based microcontrollers on both SWD and JTAG interfaces
• Programming (TPI) of all Atmel tinyAVR ® 8-bit microcontrollers with support for this interface
• Datasheet

Atmel-ICE Features:

• ● Fully compatible with Atmel Studio
• ● Supports programming and debugging of all Atmel AVR UC3 32-bit microcontrollers
• ● Supports programming and debugging of all 8-bit AVR XMEGA devices
• ● Supports programming and debugging of all 8-bit Atmel megaAVR ® and tinyAVR devices with OCD
• ● Supports programming and debugging of all SAM ARM Cortex-M based microcontrollers
• ● Target operating voltage range of 1.62V to 5.5V
• ● Draws less than 3mA from target VTref when using debugWIRE interface and less than 1mA for all other interfaces
• ● Supports JTAG clock frequencies from 32kHz to 7.5MHz
• ● Supports PDI clock frequencies from 32kHz to 7.5MHz
• ● Supports debugWIRE baud rates from 4kbit/s to 0.5Mbit/s
• ● Supports aWire baud rates from 7.5kbit/s to 7Mbit/s
• ● Supports SPI clock frequencies from 8kHz to 5MHz
• ● Supports SWD clock frequencies from 32kHz to 2MHz
• ● USB 2.0 high-speed host interface
• ● ITM serial trace capture at up to 3MB/s
• ● Supports 10-pin 50-mil JTAG connector with both AVR and Cortex pinouts. The standard probe cable supports AVR 6-pin ISP/PDI/TPI 100-mil headers as well as 10-pin 50-mil. An adapter is available to support 6-pin 50-mil, 10-pin 100-mil and 20-pin 100-mil headers. Several kit options are available with different cabling and adapters.