W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)
      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)
      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)
      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)
      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)

      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)

      ER-ASW51001E
      29,88 €

      24.90 € bez DPH

      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)

      Množstvo:
      OUT OF STOCK

      W5100 Ethernet Shield for Arduino (ER-ASW51001E)

      The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100ethernet chip . The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top. 

          The Ethernet Shield has a standard RJ-45 connection, with an integrated line transformer and Power over Ethernet enabled. 
      There is an onboard micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino, Crowduino and Mega (using the Ethernet library). The onboard microSD card reader is accessible through the SD Library. When working with this library, SS is on Pin 4.

      Specification

      • Operating voltage 5V (supplied from the Arduino Board)
      • Ethernet Controller: W5100 with internal 16K buffer
      • Connection speed: 10/100Mb
      • Connection with Arduino on SPI port
      • The Shield  contains a number of informational LEDs
        • PWR: indicates that the board and shield are powered
        • LINK: indicates the presence of a network link and flashes when the shield transmits or receives data
        • FULLD: indicates that the network connection is full duplex
        • 100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s)
        • RX: flashes when the shield receives data
        • TX: flashes when the shield sends data
        • TX: flashes when the shield sends data
        • COLL: flashes when network collisions are detected

       

      Wiki & External links

      ELECROW
      ER-ASW51001E

      Špecifické referencie

      W5100 Ethernet Shield for Arduino (ER-ASW51001E)

      W5100 WIZnet Ethernet Shield for Arduino (ER-ASW51001E)

      29,88 €

      24.90 € bez DPH