KiwiSDR Kit (SE-110060490)
      KiwiSDR Kit (SE-110060490)
      KiwiSDR Kit (SE-110060490)
      KiwiSDR Kit (SE-110060490)

      KiwiSDR Kit (SE-110060490)

      SE-110060490

      KiwiSDR Kit (SE-110060490)

      Quantity :

      KiwiSDR Kit (SE-110060490)

      KiwiSDR is a software-defined radio (SDR) covering shortwave, the longwave & AM broadcast bands, various utility stations, and amateur radio transmissions, world-wide, in the spectrum from 10 kHz to 30 MHz. The KiwiSDR is a custom circuit board (cape) you connect to theBeagleBone GreenorBeagleBone Black computer. You simply add an antenna, power supply and network connection. The KiwiSDR is available in two versions: the cape alone and a more complete version including BBG, enclosure and GPS antenna. Both versions include software supplied on a micro-SD card.

      An HTML5-capable browser and internet connection will let you listen to a public KiwiSDR anywhere in the world. Up to four people can listen simultaneously to one radio — each listener tunes independently.

      Try it right now! Listen to KiwiSDR registered on the sdr.huwebsite.

      Features

      • 100% Open Source / Open Hardware.

      • Browser-based interface allowing four simultaneous user web connections.

      • Each connection tunes an independent receiver channel over the entire spectrum.

      • Waterfall tunes independently of audio and includes zooming and panning.

      • Multi-channel, parallel DDC design using bit-width optimized CIC filters.

      • Good performance at VLF/LF since we personally spend time monitoring those frequencies.

      • Automatic frequency calibration via received GPS timing.

      • Easy hardware and software setup. Browser-based configuration interface.

      • Extension interface for adding decoders and utilities.

      Specification

      • SDR covers the 10 kHz to 30 MHz (VLF-HF) spectrum.

      • Web interface based on OpenWebRX from András Retzler, HA7ILM.

      • Demodulation modes: AM, AMN, LSB, USB, CW, CWN, NBFM.

      • Extensions at present: WSPR viewer/decoder, IQ display, Loran-C      viewer.

      • RF antenna connector: SMA and terminal block.

      • Integrated software-defined GPS receiver from Andrew Holme's Homemade GPS Receiver.

      • GPS receives the Navstar system on L1 frequency 1575.42 MHz.

      • GPS antenna connector: SMA, 3.3V powered for active antennas.

      • Voltage: +5V DC, 2.1mm jack, center pin positive.

      • Current: 1.5A including Beagle, KiwiSDR powers Beagle through header connectors.

      • Dimensions: KiwiSDR PCB 117mm * 55mm, SMA connectors additional.

      Part List

      • 1 x KiwiSDR Board

      • 1 x Beaglebone Green

      • 1 x Unassembled enclosure

      • 1 x Skyworks SE4150L GPS front-end antenna

      • 1 x Micro-SD Card

      Documents

      • For source code and issues list, please visit our Githubpage.

      • For technical discussion, please come to our Forum.

      • For projects that you would like to share with the community, please visit Recipe.

      Seeed Studio
      SE-110060490

      Specific References

      KiwiSDR Kit (SE-110060490)

      KiwiSDR Kit (SE-110060490)