Gertbot Robotics Raspberry Pi B+, Pi 2B, RASP GERTBOT, Raspberry Pi

Deska Gertbot Robotics je doplňkový modul pro Raspberry Pi, který se připojuje přímo k pinům GPIO. Je zaměřena především na pohon motorů, díky čtyřem integrovaným H-můstkům může pohánět až čtyři stejnosměrné motory napájené napětím až 30 V při 2.5 A nebo dva krokové motory.

Gertbot motor controller board for Raspberry Pi
Gertbot is an add-on printed circuit board for the 64-MHz ARM cortex-M0 processor for Raspberry Pi (all models). 

Allows the Raspberry Pi to control and drive a wide range of motors, such as stepper motors and brushed motors. This supports Pi's ability to drive at 30 V and 2.5 A. Gertbot can also be used as a stand-alone board and be controlled from any computer with a serial UART connection. 

•Extremely easy to set up
•Easy to control thanks to high-level commands
•Capacity for up to 4 additional boards
•Outputs have short-circuit and over-temperature protection

•The board can be controlled without programming

•Datasheet

The board is supplied with drivers, sample code and a user-friendly user interface — perfect for those who want to get started right away!