By continuing use this site, you agree to the Terms & Conditions and our use of cookies.
      MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)
      • MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)
      • MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)
      • MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)

      MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)

      BOB-11420
      €23.88
      Tax included

      19.90 € tax excl.

      MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)

      Quantity :
      • Secure purchase
      • Fast delivery
      • Purchase help

      MiniGen - Pro Mini Signal Generator Shield (Sparkfun BOB-11420)

      This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Thought the MinioGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

      The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

      Features:

      • 10-bit DAC for good accuracy
      • 2 frequency registers
      • 2 phase registers
      • SPI Interface Driven at 40MHz
      • Operating Voltage: 3.3V (5V when jumper is soldered)

       

      Documents:

      SparkFun
      BOB-11420

      Specific References

      16 other products in the same category: