By continuing use this site, you agree to the Terms & Conditions and our use of cookies.
      UM232H-B-WE (FTDI) Development Module for FT232H with a Wire Ended Connector
      • UM232H-B-WE (FTDI) Development Module for FT232H with a Wire Ended Connector

      UM232H-B-WE (FTDI) Development Module for FT232H with a Wire Ended Connector

      UM232H-B-WE
      €27.54
      Tax included

      22.95 € tax excl.

      UM232H-B-WE (FTDI) Development Module for FT232H with a Wire Ended Connector

      Quantity :
      • Secure purchase
      • Fast delivery
      • Purchase help

      UM232H-B-WE (FTDI) Development Module for FT232H with a Wire Ended Connector

      The UM232H-B-WE is a development module for FT232H with a wire ended  connector. It is a development module for FTDI’s FT232H Hi-Speed to Serial/Parallel interface converter. This single interface channel IC can be configured to transfer data over the following interfaces UART, 245 FIFO, FT1248, I2C, SPI and GPIO.

      This hardware is a breakout board that converts Hi-Speed USB2.0 to a serial/parallel interface and connects the signals to a 2.00mm pitch 18pin female receptacle. No USB connector is used, instead this modules plugs directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the host USB connector. All signals on these modules operate at +3.3V voltage levels, however all I/Os are 5V tolerant.

      Datasheet

      UM232H-B-WE

      Specific References

      Customers who bought this product also bought:

      16 other products in the same category: