RLX COMPONENTS s.r.o. , Electronic Components Distributor.
RLX COMPONENTS s.r.o. , Electronic Components Distributor.
128x128, General 1.5inch OLED display Module (WS-13992)
WS-13992
€13.42
10.91 € tax excl.
128x128, General 1.5inch OLED display Module (WS-13992)
128x128, General 1.5inch OLED display Module (WS-13992)
DESCRIPTION
1.5inch OLED display Module, 128x128 pixels, 16-bit grey level, SPI/I2C interface
Overview
This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16-bit grey level, with embedded controller, communicating via SPI or I2C interface.
Features
- 128x128 high resolution
- 16-bit grey level, better display effect
- Supports SPI or I2C interface, configured via onboard resistor
- Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
Specifications
- Driver: SSD1327
- Interface: SPI / I2C
- Display color: White
- Grey level: 16-bit
- Resolution: 128x128 (most other competitive products are typically 128x64)
- Viewing angle: >160°
- Operating voltage: 3.3V / 5V
- Dimension: 44.5 x 37 (mm)
Interface
| SYMBOL | DESCRIPTION |
|---|---|
| VCC | Power (3.3~5V input) |
| GND | Ground |
| DIN | Data input |
| CLK | Clock data input |
| CS | Chip selection, low active |
| DC | Data/Command selection (high for data, low for command) |
| RST | Reset, low active |
There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:
| BS | CS | DC | DIN | CLK | |
|---|---|---|---|---|---|
| 4-wire SPI | 0 | Chip select | Data/Command | MOSI | SCK |
| I2C | 1 | NC | I2C address selection | SDA | SCL |
Dimensions
Development Resources
Wiki : www.waveshare.com/wiki/1.5inch_OLED_Module
Selection Guide
| Part Number | Color | Resolution | Display Size (mmxmm) | Interfaces | Driver | Dimension (mmxmm) | Pinheader |
|---|---|---|---|---|---|---|---|
| 0.95inch RGB OLED (A) | 65K colorful | 96x64 | 20.14x13.42 | SPI(4-wire SPI) | SSD1331 | 31.7x37.0 | angled/horizontal |
| 0.95inch RGB OLED (B) | 65K colorful | 96x64 | 20.14x13.42 | SPI(4-wire SPI) | SSD1331 | 31.7x37.0 | straight/vertical |
| 0.96inch OLED (A) | 1/4 yellow section, 3/4 blue section | 128x64 | 21.7x11.2 | 3-wire SPI, 4-wire SPI, I2C | SSD1306 | 33.0x33.5 | angled/horizontal |
| 0.96inch OLED (B) | 1/4 yellow section, 3/4 blue section | 128x64 | 21.7x11.2 | 3-wire SPI, 4-wire SPI, I2C | SSD1306 | 33.0x33.5 | straight/vertical |
| 1.3inch OLED (A) | Blue | 128x64 | 29.42x14.7 | 3-wire SPI, 4-wire SPI, I2C | SH1106 | 40.5x37.5 | angled/horizontal |
| 1.3inch OLED (B) | Blue | 128x64 | 29.42x14.7 | 3-wire SPI, 4-wire SPI, I2C | SH1106 | 40.5x37.5 | straight/vertical |
| 1.5inch OLED Module | White (16-bit grey level) | 128x128 | 26.86x26.86 | 4-wire SPI, I2C | SSD1327 | 44.5x37.0 | PH2.0 connector |
Note: the 0.96inch OLED consists of 1/4 yellow upper section and 3/4 blue lower section, not a regular dual-color display.
WS-13992
Specific References
128x128, General 1.5inch OLED display Module (WS-13992)
128x128, General 1.5inch OLED display Module (WS-13992)
€13.42
10.91 € tax excl.