DE10-Nano Kit  Development Kit (TERASIC) P0496

The DE10-Nano Development Kit presents a robust hardware design platform built around the Intel System-on-Chip (SoC) FPGA, which combines the latest dual-core Cortex-A9 embedded cores with industry-leading programmable logic for ultimate design flexibility. Users can now leverage the power of tremendous re-configurability paired with a high-performance, low-power processor system. Altera’s SoC integrates an ARM-based hard processor system (HPS) consisting of processor, peripherals and memory interfaces tied seamlessly with the FPGA fabric using a high-bandwidth interconnect backbone. The DE10-Nano development board is equipped with high-speed DDR3 memory, analog to digital capabilities, Ethernet networking, and much more that promise many exciting applications. The DE10-Nano Development Kit contains all the tools needed to use the board in conjunction with a computer that runs the Microsoft Windows XP or later.

The DE10-Nano board has many features that allow users to implement a wide range of designed circuits, from simple circuits to various multimedia projects.

The following hardware is provided on the board:

FPGA Device

• Intel Cyclone® V SE 5CSEBA6U23I7  device (110K LEs)
• Serial configuration device  – EPCS64 (revision B2 or later)
• USB-Blaster II onboard for programming; JTAG Mode
• HDMI TX, compatible with DVI 1.0 and HDCP v1.4
• 2 push-buttons
• 4 slide switches
• 8 green user LEDs
• Three 50MHz clock sources from the clock generator
• Two 40-pin expansion headers
• One Arduino expansion header (Uno R3 compatibility), can be connected with Arduino shields
• One 10-pin Analog input expansion header (shared with Arduino Analog input)
• A/D converter, 4-pin SPI interface with FPGA

* If the specification of memory device in Quick Start Guide and official website is discordant, refer to DE10-Nano website as the sole stardard.

HPS (Hard Processor System)

• 800MHz Dual-core ARM Cortex-A9 processor
• 1GB DDR3 SDRAM (32-bit data bus)
• 1 Gigabit Ethernet PHY with RJ45 connector
• USB OTG Port, USB Micro-AB connector
• Micro SD card socket
• Accelerometer (I2C interface + interrupt)
• UART to USB, USB Mini-B connector
• Warm reset button and cold reset button
• One user button and one user LED
• LTC 2x7 expansion header

Block Diagram of the DE10-Nano Board

Connectivity

• Connect LT24

• Connect Arduino

• Connect MTL2

• Connect D8M

• Connect D5M

• Connect LTC2607 (AD/DA Daugher Card)

Kit Contents

1. DE10-Nano Board
2. DE10-Nano Quick Start Guide
3. Type A to Mini-B USB Cable x1
4. Type A to Micro-B USB Cable x1
5. Power DC Adapter (5V)
6. microSD card (installed)
7. Four Silicon Footstands