ARDUINO UNO R3 PLUS, Compatible with Arduino UNO R3 (A000066), ATMEGA328P-AU

Kód WS-10205 (A000066)

ARDUINO UNO R3 PLUS, Compatible with Arduino UNO R3, ATMEGA328P-AU

UNO PLUS, Arduino UNO improved (Waveshare UNO PLUS)

UNO PLUS is a development board compatible with the Arduino UNO R3, an improved & enhanced alternative solution for Arduino UNO R3.

UNO PLUS Features

UNO PLUS is a development board compatible with the Arduino UNO R3, an improved & enhanced alternative solution for Arduino UNO R3.

UNO PLUS Vs UNO R3：

	UNO PLUS	UNO R3	Remarks
Operating voltage	5V/3.3V	5V	Dual voltage level to support more shields
Reset	Lateral	Vertical	Lateral button is easier to use when connecting with shield
Bootloader switch	Yes	None	The board can be configured to run program immediately when power-up by the switch
USB connector	Micro USB	USB Type B	Micro connector is more commonly used, and shields won't be blocked anymore while connecting
DC jack	Low profile	Normal height	Shields won't be blocked anymore while connecting
Power output header	Yes	None	Providing 5V/3.3V power output OR common-grounding with other boards
3.3V power output	800mA Max	150mA Max	UNO PLUS features higher driving capability
Oscillator	Crystal oscillator	Ceramic resonator	Crystal oscillator is suit for applications where accurate clock reference is required
ADC channel	8	6	CFG used as ADC6 by configuration, and ADC7 from the Reserved PIN
Connecting with prototype breadboard	Supported	Not supported	Solder pads is provided for DIY interfaces to connecting with prototype breadboard
USB driver	Compatible with all main systems	Doesn't compatible with WIN7/WIN8 Express Edition	Driver will never failed to install thanks to the onboard FT232
Firmware fixing	Supported	Not supported	Firmware can be fixed by using the onboard FT232, no extra programmer is needed

ATMEGA328P-AU
AMS1117-3.3 : 3.3V voltage regulator
NCP1117ST50T3G : 5V voltage regulator
FT232RL : USB to UART convertor
Arduino interface
- compatible with standard Arduino interface with two additional analog inputs A6 (config the CFG), A7
- solder pads provided, supports prototype breadboard
ICSP interface
MICRO USB connector : for uploading program OR serial port debugging
Power output header : 3.3V OR 5V, voltage level configured by the onboard power configuration switch, used as power output OR common-grounding with other boards
FT232 pins : for burning Bootloader into the microcontroller
DC input : 7V ~ 12V
Reset button
Power indicator
Serial port Rx/Tx indicator
User LED
Power configuration switch : for configuring the operating voltage
Bootloader selection switch
- turn ON : the board will reset when power-up OR other USB devices were detected connecting to the PC
- turn OFF : the onboard program runs immediately when power-up, and the board will not reset when other USB devices were detected connecting to the PC