Raspberry Pi2 2x20pin OLED Add-on V2.0 (Itead IM150627004)

There are seldom OLED add-ons customized for Raspberry Pi in the open source hardware market. In a lot of projects, we only need to display little information such as the state of system or IP. What’s more, when we have a high requirement for its portability, it’s unsuitable to connect a big screen to Raspberry Pi via HDMI interface. Thus, a tiny OLED add-on can satisfy this demand. OLED add-on with built-in 0.96" 128*64 OLED and SSD1306 control chip is customized for Raspberry Pi. Every single pixel in OLED can be lighted up or off by this SSD1306 control chip.

We not only offer an easily-plugged add-on for Raspberry Pi, but also provide an SDK that help you transplant Arduino’s driver into Raspberry Pi. After installing the SDK, you can drive this add-on as easily as you do on Arduino.

Feature

• Customized for Raspberry Pi, plug and play without wiring
• 0.96" OLED with 128*64 pixels
• Stackable
• Coming with 2.54 interface for Electronic bricks

 

Documents

Please visit our wiki page for more info about this product. It will be appreciated if you can help us improve the documents by correcting the errors, adding more demo codes or tutorials.

Overview

There are seldom OLED add-ons in the open source hardware market, customized specifically for Raspberry Pi. In many projects, we only need to display little information such as the state of system or IP address. What`s more, when users have a high requirement for its portability, it`s unsuitable to connect a big screen to Raspberry Pi via HDMI interface. Thus, a tiny OLED add-on can satisfy this user demand.

OLED add-on with built-in 0.96" 128*64 OLED and SSD1306 control chip is customized for Raspberry Pi. Each pixel in OLED can be lighted up or off by this SSD1306 control chip.

We not only offer an easy plug in, add on for Raspberry Pi but also provide an SDK that enables users to transplant Arduino's driver into Raspberry Pi. After proper installation of the SDK, users can drive this add on as easily as if using it on Arduino.

Check out the amazing features of this product below:

Feature

•Customized for Raspberry Pi, plug and play without any wiring

•0.96" OLED with 128*64 resolution

•Stackable

•Coming with 2.54 interface for Electronic bricks

The V1.0 is customized for Raspberry Pi:

Technical support

For technical support, please open a ticket on Itead Support System.