Pi Supply Gert VGA 666  Hardware VGA for Raspberry Pi - DYI - STAVEBNICA !

Description

The Gert VGA 666 (6 bits per colour channel, hence 666) is a breakout/add-on board for the Raspberry Pi Model B+ (will not work with Model A/B as the additional GPIO pins on the Model B+ are required). It is an open source hardware design recently released publicly by Gert van Loo who was one of the hardware engineers that was instrumental in the initial design of the original Raspberry Pi (also one of the chip architects on the BCM2835 chip at the heart of the Raspberry Pi) and someone that many of you may have spoken to at Raspberry Jams or on the Raspberry Pi forums. It is a neat and very useful solution for using a VGA screen/monitor with your Raspberry Pi and is far cheaper than an HDMI to VGA adapter or similar. The VGA connection is driven natively in hardware over the GPIO pins (using a parallel interface) and uses around the same CPU load as the HDMI connection on board. It is capable of displaying 1080p60 VGA video with no CPU load. It is also possible to drive this interface at the same time as the HDMI connection, so a dual screen setup is also possible. This add-on was not possible on the Model A and B pis, because not all of the required pins had been brought out to the GPIO header. Yet another awesome upgrade that the Model B+ has allowed for! 

Gert VGA 666 Kit Contents

• 1 x Gert VGA 666 PCB
• 1 x 40 pin GPIO header connector
• 1 x 15 pin female VGA connector
• 20 x through hole resistors (2× 120Ω, 3× 499Ω, 3× 1kΩ, 3× 2kΩ, 3× 4kΩ, 3× 8kΩ, 3× 16kΩ)
• 2 x Pi Supply Stickers

Tutorials

• Raspberry Pi Announcement 
• Full design files, schematics and other details are available on GitHub.

• Assembly Tips And Gotchas