* replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)
      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)
      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)
      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)
      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)

      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)

      ER-CDP03509S

      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)

      Množstvo:

      CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)

      The Arduino CNC Shield makes it easy to get your CNC projects up and running in a few hours. It uses opensource firmware on Arduino to control 4 stepper motors using 4 A4988 Stepper drivers,, with this shield and the Crowduino you can build all kinds of robotics or CNC projects including CNC routers,laser cutters and even pick&place machines.

          
      NOTE that the CNC Shield PCB you receive would be RED and the Crowduino& A4988 stepper drivers in the picture not included.

      Features

      • GRBL 0.9 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signalshttps://github.com/grbl/grbl)
      • 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13)
      • 2 x End stops for each axis (6 in total)
      • Coolant enable
      • Uses removable Pololu A4988 compatible stepper drivers. (A4988, DRV8825 and others)(Not Included)
      • Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping )
      • Compact design.
      • Stepper Motors can be connected with 4 pin molex connectors or soldered in place. .
      • Runs on 12-36V DC. (At the moment only the Pololu DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)

      Useful Links

      ELECROW
      ER-CDP03509S

      Špecifické referencie

      CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)

      * replaced ER-CDP03051C *CNC Shield V3.5 for Arduino (GRBL v0.9 compatible with PWM Spind (ER-CDP03509S)