OLED display 128x128 1.5inch RGB Module, 16-bit high color (WS-14747)

1.5inch RGB OLED display module, 128x128 pixels, 16-bit high color, SPI interface

Overview

This is a general RGB OLED display Module, 1.5inch diagonal, 128x128 pixels, 16-bit high color (65K colors), with embedded controller, communicating via SPI interface.

Features

• 128x128 high resolution, 65K colors, clearly displays colorful images
• Supports 4-wire SPI OR 3-wire SPI interface, configured via onboard resistor
• Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications

• Driver: SSD1351
• Interface: 4-wire SPI, 3-wire SPI
• Display color: RGB, 65K colors
• Resolution: 128x128
• Viewing angle: >160°
• Operating voltage: 3.3V / 5V
• Dimension: 44.5 x 37 (mm)

Interface

SYMBOL	DESCRIPTION
VCC	Power (3.3~5V input)
GND	Ground
DIN	Data input
CLK	Clock data input
CS	Chip selection, low active
DC	4-wire SPI: Data/Command selection (high for data, low for command) 3-wire SPI: Connects to GND, keeps low
RST	Reset, low active

There are two available drive interfaces for this RGB OLED module: 4-wire SPI (default) and 3-wire SPI:

	BS	DC
4-wire SPI	0	DC
3-wire SPI	1	Connects to GND

Dimensions

Development Resources

Wiki : www.waveshare.com/wiki/1.5inch_RGB_OLED_Module

Package Content

1. 1.5inch RGB OLED Module x1
2. PH2.0 7Pin x1

Selection Guide

Part Number	Color	Resolution	Display Size (mmxmm)	Interfaces	Driver	Dimension (mmxmm)	Pinheader
0.91inch OLED Module	White	128x32	22.38×5.58	I2C	SSD1306	36.0x12.5	PH2.0 connector
0.95inch RGB OLED (A)	65K colorful	96x64	20.14x13.42	SPI(4-wire SPI)	SSD1331	31.7x37.0	angled/horizontal
0.95inch RGB OLED (B)	65K colorful	96x64	20.14x13.42	SPI(4-wire SPI)	SSD1331	31.7x37.0	straight/vertical
0.96inch OLED (A)	1/4 yellow section, 3/4 blue section	128x64	21.7x11.2	3-wire SPI, 4-wire SPI, I2C	SSD1306	33.0x33.5	angled/horizontal
0.96inch OLED (B)	1/4 yellow section, 3/4 blue section	128x64	21.7x11.2	3-wire SPI, 4-wire SPI, I2C	SSD1306	33.0x33.5	straight/vertical
1.3inch OLED (A)	Blue	128x64	29.42x14.7	3-wire SPI, 4-wire SPI, I2C	SH1106	40.5x37.5	angled/horizontal
1.3inch OLED (B)	Blue	128x64	29.42x14.7	3-wire SPI, 4-wire SPI, I2C	SH1106	40.5x37.5	straight/vertical
1.5inch OLED Module	White (16 gray scale)	128x128	26.86x26.86	4-wire SPI, I2C	SSD1327	44.5x37.0	PH2.0 connector
1.5inch RGB OLED Module	65K colorful	128x128	26.86x26.86	3-wire SPI, 4-wire SPI	SSD1351	44.5x37.0	PH2.0 connector

Note: the 0.96inch OLED consists of 1/4 yellow upper section and 3/4 blue lower section, not a regular dual-color display.