ODROID-H2 Case Type 4 (Hardkernel) G181116640066

Description:

This “Case Type 4” is designed for the user who needs high bandwidth network with mid-range storages. Basically, this is the fanless design and the heated air from a processor or the storages – especially a hard disk drive with a spinning motor – can be blow out through the two 92mm holes  on top of the ODROID-H2 and the disk drives. But you also can install a 92x92mm standard PC cooling fan (optional) at a hole out of two on top of the ODROID-H2 if you supply the decent power for the fan.

• Supported storages: Due to the physical limitation of the design, two different size of storages cannot be installed and below combination of the storage drives are supported.

On-board eMMC 5.1 module

On-board M.2 NVMe (NGFF-2280)

Up to 1 x 3.5” SATA HDD or SSD

Up to 2 x 2.5” SATA HDD or SSD (Max height : 15mm)

• “SATA Data and Power Cable” must be purchased

• The disk drive mounting screws (M3x6mm and #6-32x6mm) are included in the package.

• The power and reset switches are accessible through the hole at the front

• Optional power on/off switch (diameter 16mm) can be installed at the front

• 209 (L) x 132 (W) x 106 (H) mm

 

Package Contents:

• A. Rear-top panel

• B. Front panel

• C. Rear-back panel

• D. Rear panel

• E. Front space filler

• F. Bottom panel

• G. 2.5”/3.5” inner drive bracket

• H. Left panel

• I. Right panel

• J. Top panel

• K. 1 x 92mm stainless cooling fan grill for front-top

• L. 1 x 92mm stainless cooling fan grill for rear-top

• M. 6 x 40mm (F) PCB Supports

• N. 3 x 40mm (M) PCB Supports

• O. 4 x 15mm (M) PCB Supports

• P. 6 x 6mm #6-32 Round Head Screws

• Q. 8 x M5 Truss Head Bolts

• R. 20 x 6mm Truss Head Bolts

• S. 8 x M5 Nuts

• T.  4 x Rubber Feet (Round / Clear)

 

Optional accessory:

• SATA Data and Power Cable
• LED Power Button
• 16Port I2C GPIO Board
• 92x92x25mm DC 5V Cooling Fan

Mechanical drawings:

• https://dn.odroid.com/temp/box/ODROID-H2_TYPE4.dxf